Fixed possible holder gouges or incorrect trimming in 3D Contour when using the 'Trim' option for holder and the 'Axial stock to leave' option.

Fixed a case where a toolpath wasn't calculated for contour strategies when using a tool with a shaft that was wider than the tool body.

Fixed an issue with missing offset paths for 2D Contour and 2D Pocket.

Fixed an issue where overlapping contours and contour selections with no area could cause a crash of the toolpath calculation.

Fixed an issue in some 2D Contour cases where a badly formed stay-down link could be generated when using a user defined exit position.

Fixed a crash that could occur in 2D Contour when 'Loops around corners' and 'Trimming' were enabled.

Improve the feed rate calculation when 'stock contours' are used for certain 2D strategies.

Improved support for arcs in all contour based operations.

Installation WHAT’S NEW The following changes have been made in the current update (2023.1):

HSMWorks Ultimate (including Fusion Entitlement).

This document covers the following HSMWorks products:

Hsmworks